ESP CanCam Manual de instrucciones descargar pdf (Pagina 9)

Battery and Memory Installation

WARNING : Do not use different Voltage batteries other than the one specified in this•

section. Doing so will damage the camera and will void the warranty.

WARNING : ALWAYS have the camera in the OFF position when installing or removing•

batteries and SD card. Removing batteries or memory card while the camera is ON

may damage the camera.

Your CanCam is designed to operate using two different types of battery power options.

Batteries “C” cell

The internal battery compartment accepts 4 “C” cell batteries. Be sure to use high

quality brand name alkaline batteries. Install batteries with correct polarity (+/-) as

noted inside the battery compartment.

DC 6V external power

The camera is equipped with an external power jack designed to accept a barrel plug

cable of the DC 6V adaptor.

Make sure the camera is in the OFF position.•

Insert the external AC to DC power adaptor barrel plug into the DC 6V jack on the•

bottom of camera housing.

Turn the switch to CAM or PSET.•

Memory Options

The camera is equipped with an expandable media card slot capable of accepting up to

32GB SD card with Class 6 or below speed rating. The LCD display will show the number

of images stored on the SD card. If no SD card is inserted the front counter display will

show “NOSd”.

Once memory capacity is up to full, the camera will re-loop the memory to keep the

last image and delete the first image from the memory.

Inserting SD memory card

NOTE: Make sure camera is in the OFF position whenever adding or removing the

SD card.

Insert the SD card into the SD card slot completely and in the correct direction as•

shown by the sticker located on the side of the housing.

To remove the SD card, depress the SD card and pull out the card gently.•

SD cards must be formatted. Make sure to format the SD card in a computer prior to•

use in the camera.

FORMAT – Definition : When formatting a SD memory card, the operating system erases

all information and files on the card. Then it creates an internal address table that is

later used to locate information and files.

DO NOT USE File System type: “NTFS” or “exFAT”, these formats are not supported.

CanCam Manual_Layout 5 05/09/2013 12:22 Page 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Sin comentarios

ESP CanCam Manual de instrucciones Pagina 9